www.tacticalsubmission.com

Perfect for adding a compliant part to your old surplus magazines or to revive an old magazine.  Designed for 20, 30, and 40rd magazines.  This high capacity follower for the AK is constructed of the highest quality composite to ensure optimum performance.

GLOCK Mid and Full Size model Grip Frame Insert. This unit installs in the bottom rear cavity of the frame utilizing the lanyard hole for retention. Fits 17,18,19,20,21,22,23,24,25,31,32,34,35,37,38

This tool is designed to remove pins in Glock handguns. It features a polymer handle and a steel tip. Fits all Glock models.

Glock factory manufactured magazine extension. Attach to the bottom of any 9mm, .40 S&W or .357 Sig caliber Glock magazine and increase your capacity of ammunition by two extra shots.

The TAPCO AR Front Sight Tool is a four post model designed to work with the A2 front sight. Machined from 4140 steel and finished in black oxide, our tool will provide years of use and is backed by our lifetime warranty. The lanyard hole allows attachment to your key ring and provides a location to tie down the tool to prevent loss. The TAPCO Front Sight Tool can also be stored in the Intrafuse Vertical Grip and SAW Style Pistol Grips. Fits the AR15, M16 and M4.

Assembly/dis-assembly tool for removing the buffer tube, featuring three lugs that accurately engage the indents on the receiver extension nut.

The MOE Trigger Guard is an enhanced polymer drop in replacement for the AR15/M16 weapons platform. It features a shallow "V" shape for better use of gloves in tactical shooting or cold weather operations. The MOE Trigger Guard is non-folding, has rounded edges, and fills the annoying "gap" at the rear of the standard trigger guard. Also works well with most 7.62x51 AR platforms but some custom fitting may be required. All mounting hardware included.

Assembly/dis-assembly tool for removing the buffer tube, featuring three lugs that accurately engage the indents on the receiver extension nut. This tool is stamped from heavy gauge steel (not that flimsy crap) with a protected handle for comfortable use. The Carbine Wrench is so well built you will never wear it out and comes with our lifetime guarantee. It is required to install our X-180 Sling Mount.

This tool is a necessity for any AR style rifle shooter or agency armorer.  It eases the removal of the handguards on both carbines and full sized rifles.  All areas that contact the rifle are protected to prevent damage to the finish of the rifle. Fits the AR15, M16 and M4.

Large, mushroom shaped head "TELLS" you if the safety is in the on position when finger is on the trigger. Safety can then be moved to fire position with second joint of trigger finger without moving finger from trigger. Made from heat treated 4140 steel in matte black to match finish of weapon. Can be installed for left or right hand use.

Spool shaped handle allows rapid manipulation of bolt without "Biting". Makes operation of handle simple with either hand. Made From Heat Treated 4140 steel, matte black to match finish of weapon.

Complete carry handle for AR type rifles. Fits on flat top receivers and acts as a carry handle and rear sight system. Fully adjustable rear sight with windage and elevation clicks. Can be used with a variety of scopes, lasers and lights. Fits M-16 and AR-15 variants.

Holds AR15 type receivers from the inside. Can't crush receiver or mar finish. Allows turning or threading end of barrel in lathe without removal of receiver, sight base, gas tube, or hand guards. Facilitates removal of barrel using either a lathe or vice. Can take up to three times the recommended barrel nut torque without distortion of receiver. Tool Extends from rear of receiver with provisions for use in conjunction with any lathe chuck, vice or 5/8" wrench